Kit High Output Stator + High Performance CDI Box for Honda TRX 250 R 1988-1989

CAD$ 274.00
Availability: Out of stock
SKU
RM22973
RM22973-R00
High Ouptut Stator :
Interior diameter : 34mm
Exterior diameter : 88mm
Thickness : 17mm
Length of wires stator to grommet : 60mm
Length of wires grommet to plug : 60mm & 620mm
Length of pickup coil's wire to grommet : 80mm

Other specifications :
Number of wires : 4
Number of plugs : 3
Number of pins : 4

Wire to wire resistance :
Alternator : White to Ground = 04.4 ohms +/-20%
Pickup : Green to Blue = 115 ohms +/-20%
Source : Black/Red to Ground = 210 ohms +/-20%

CDI Box
Height: 25mm
Length: 80mm
Width: 49mm

Other specifications:
Number of plugs: 2
Number of pins: 6

The only real way to test your CDI box is to swap it out with another known good unit from the same year/make/model. Because of this, we recommend that you rule everything else out before replacing the CDI box.
Before installing your new stator:
  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulator/rectifier
  • Check and repair any melted wiring.
  • Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code then youメre original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010メメ.

CDI box
Our CDI may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This CDI is designed as a direct plug-in replacement and should be used as such.

Brand New Kit High Output 200W Stator + High Performance CDI Box

  • Direct replacement to your original unit
  • All shipped products are tested

*All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.

High output stator 200 watts
  • Highest grade of lamination materials
  • Highest grade of copper winding, resistant to 200 degrees Celsius
  • Pick up pulsar coil included
  • Connector included
  • Rubber grommet included
  • Back Plate included
High Performance CDI Box
  • Enhanced timing curve, increased rev limiter (approximately 1000 rpm)
  • Higher grade of electronic components
  • The Quality exceeds the OEM equipment
Write Your Own Review
You're reviewing:Kit High Output Stator + High Performance CDI Box for Honda TRX 250 R 1988-1989
Your Rating
Customers Also Viewed
Currently there is no product to display.