Kit Stator 200 W + Regulator Rectifier + CDI Box + Ignition Coil + Flywheel Puller for Yamaha YFZ 350 Banshee 1997-2006

CAD$ 647.00
Availability: In stock
SKU
RM22856
RM22856

Stator:
Interior diameter : 34 mm
Exterior diameter : 103 mm
Thickness : 27 mm
Length of wires stator to grommet : 60 mm
Length of wires grommet to plug : 520 mm
Length of pickup coil's wire to grommet : 80 mm

Other specifications :
Number of wires : 6
Number of plugs : 3
Number of pins : 6

Wire to wire resistance :
Alternator : Yellow to Black = 0.4 ohms +/-20%
Pickup : White/Green to White/Red = 115 ohms +/-20%
Source : Green to Red = 12 ohms +/-20%

CDI Box
Height: 71 mm
Length: 87 mm
Width: 26 mm
Fixation holes center to center: 85 mm

Other specifications:
Number of plugs: 2
Number of pins: 8

External Ignition Coil
Fixation holes center to center: 90 mm

Before installing your new stator
  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulator/rectifier
  • Check and repair any melted wiring.
  • Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.

When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".

CDI Box HP

Our CDI may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This CDI is designed as a direct plug-in replacement and should be used as such.

Voltage Regulator Rectifier
  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulator/rectifier
  • Check and repair any melted wiring.
  • Use hi-temp dielectric grease on all connectors.

External ignition coil

Remove the yellow wire from the external ignition coil, if it is not applicable to your model.


Brand New Kit HO Stator + Regulator Rectifier+ Peak RPM CDI Box + Flywheel Puller + External Ignition Coil

  • Direct replacement to your original unit
  • Plug-and-play, direct fit, easy installation
  • All shipped products are tested

*All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.

High output stator 200 watts
  • Highest grade of lamination materials
  • Highest grade of copper winding, resistant to 200 degrees Celsius
  • Pick up pulsar coil included
  • Connector included
  • Rubber grommet included
  • Adjustable timing plate to advance and retard up to 10 degrees included
AC Regulator
  • 12 Volts regulator used by Baja winners
  • For use with all standard halogen and quartz lights
  • Precise voltage control, eliminates light burnout
  • Reduce flickering and dimming
  • Simple installation
  • Works with all other OEM parts
  • Rated at 225 watts
PeakRPM CDI Box
  • Our PeakRPM CDI Box provides the optimal output for your ride
  • Higher grade of electronic components
  • The Quality exceeds the OEM equipment
Flywheel Puller
  • 27 MM x 1.0 Left hand male
External ignition coil
Please note : For solid tip spark plugs, you may re-use your original spark plug caps.
  • Highest grade of lamination materials
  • The Quality exceeds the OEM equipment
  • Spark plug cap(s) included

If your old parts are defective, RM Stator offer replacements parts of high qualities at a fraction of the cost of genuine parts.

Write Your Own Review
You're reviewing:Kit Stator 200 W + Regulator Rectifier + CDI Box + Ignition Coil + Flywheel Puller for Yamaha YFZ 350 Banshee 1997-2006
Your Rating
Customers Also Viewed
Currently there is no product to display.