Kit Stator + CDI + Ignition Coil + Gasket for Yamaha YFM 350 Raptor Warrior 2002-2013

CAD$ 456.00
Availability: In stock
SKU
RM22812
RM22812-R00
Stator

Interior diameter: 53 mm
Exterior diameter: 114 mm
Thickness: 13 mm

Other specifications:
Number of wires: 7
Number of plugs: 2
Number of pins: 7

Wire to wire resistance:
Alternator : White between each White = 0.4 ohms+/-20%
Pickup: Green to Blue = 518 ohms =+/-20%
Position sensor: Red to White/Blue = 0.1 ohms+/-20%

CDI Box

Height: 26 mm
Length: 109 mm
Width: 78 mm
Wires length: 120 mm

Other specifications:
Number of plugs: 2
Number of pins: 12

The only real way to test your CDI box is to swap it out with another known good unit from the same year/make/model. Because of this, we recommend that you rule everything else out before replacing the CDI box

External ignition coil
Distance between fixation holes: 55 mm

Before installing your new stator
  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulator/rectifier
  • Check and repair any melted wiring.
  • Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.

When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".

CDI Box

Our CDI may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This CDI is designed as a direct plug-in replacement and should be used as such.

External ignition coil

Remove the yellow wire from the external ignition coil, if it is not applicable to your model.

Brand New Kit Stator + PeakRPM CDI Box + External Ignition Coil + Crankcase Cover Gasket

  • Direct replacement to your original unit
  • Plug-and-play, direct fit, easy installation
  • All shipped products are tested

*All item pictures are accurate, if in doubt, do not hesitate and compare our item to your original part.


Stator
  • Highest grade of lamination materials
  • Highest grade of copper winding, resistant to 200 degrees Celsius
  • Pick up pulsar coil included
  • Connector included
  • Rubber grommet included
  • Crankcase cover gasket included

PeakRPM CDI Box
  • Our PeakRPM CDI Box provides the optimal output for your ride
  • Higher grade of electronic components
  • The Quality exceeds the OEM equipment
External ignition coil
  • Highest grade of lamination materials
  • The Quality exceeds the OEM equipment
  • Spark plug cap(s) included

If your old parts are defective, RM Stator offer replacements parts of high qualities at a fraction of the cost of genuine parts.

Write Your Own Review
You're reviewing:Kit Stator + CDI + Ignition Coil + Gasket for Yamaha YFM 350 Raptor Warrior 2002-2013
Your Rating
Customers Also Viewed
Currently there is no product to display.