Kit Stator + Crankcase Cover Gasket for Lynx Adventure / Ranger | Ski-Doo Expedition / Legend / Skandic V-800 2007 2008
- 2008 Ski-doo Skandic Tundra LT V 800 4-TEC EFI L/C
- 2008 Ski-doo Expedition V 800 Sport EFI L/C
- 2008 Lynx Adventure V-800
- 2008 Lynx Adventure Ranger V-800
- 2007 Ski-doo Skandic V 800 Tundra EFI L/C
- 2007 Ski-doo Legend Trail V 800 EFI L/C
- 2007 Ski-doo Expedition V 800 Sport EFI L/C
- 2007 Lynx Adventure V-800
Interior diameter: 41mm
Exterior diameter: 103mm
Length of wires stator to grommet: 110mm
Length of wires grommet to plug: 300mm
Number of wires: 3
Number of plugs: 1
Number of pins: 3
Wire to wire resistance:
Alternator: Yellow to Yellow = 0.4ohms +/-20%
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original. `
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010’’.
Brand New Kit Stator + Crankcase Cover Gasket
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- Highest grade of lamination materials
- Highest grade of copper winding, resistant to 200 degrees Celsius
- Connector included
- Rubber grommet included
- All shipped products are tested
All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.