Kit Stator + Rotor + Ignition Coil for KTM 50 SX / 50 SX Pro / 50 Adv. 2002-2022 | Husqvarna CR / SM / TC 50 2018-2021
Please Note : If you have an older KTM50 with black "Morini Franco" engine this kit will not fit on you vehicle
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2022 KTM 50 SX Mini
- 2021 KTM 50 SX Mini
- 2021 Husqvarna TC 50
- 2020 KTM 50 SX Mini
- 2020 Husqvarna TC 50 Mini
- 2020 Husqvarna TC 50
- 2019 KTM 50 SX Mini
- 2019 Husqvarna TC 50
- 2018 KTM 50 SX Mini
- 2018 Husqvarna TC 50
- 2017 KTM 50 SX Mini
- 2017 Husqvarna TC 50
- 2016 KTM 50 SX Mini
- 2015 KTM 50 SX Mini
- 2014 KTM 50 SX Mini
- 2013 KTM 50 SX Mini
- 2012 KTM 50 SX Mini
- 2011 KTM 50 SX Mini
- 2011 Husqvarna SM 50
- 2011 Husqvarna CR 50
- 2010 KTM 50 SX Mini
- 2009 KTM 50 SX Mini
- 2009 KTM 50 SX Junior
- 2008 KTM 50 SX Mini
- 2008 KTM 50 SX Junior
- 2008 KTM 50 Mini Adventure
- 2007 KTM 50 Senior Adventure
- 2007 KTM 50 SX Junior
- 2007 KTM 50 Mini Adventure
- 2006 KTM 50 Senior Adventure
- 2006 KTM 50 SX Junior
- 2006 KTM 50 Mini Adventure
- 2005 KTM 50 Senior Adventure
- 2005 KTM 50 SX Pro Senior
- 2005 KTM 50 SX Pro Junior
- 2005 KTM 50 Mini Adventure
- 2004 KTM 50 Senior Adventure
- 2004 KTM 50 SX Pro Senior
- 2004 KTM 50 SX Pro Junior
- 2004 KTM 50 Mini Adventure
- 2003 KTM 50 Senior Adventure
- 2003 KTM 50 SX Pro Senior
- 2003 KTM 50 SX Pro Junior
- 2003 KTM 50 Mini Adventure
- 2003 KTM 50 Junior Adventure
- 2002 KTM 50 Senior Adventure
- 2002 KTM 50 SX Pro Senior
- 2002 KTM 50 SX Pro Junior
- 2002 KTM 50 Mini Adventure
- 2002 KTM 50 Junior Adventure
- 2001 KTM 50 SX Pro Senior
Stator Dimensions :
Length of wires stator to grommet : 75 mm
Length of wires grommet to plug : 148 mm
Other specifications :
Number of wires : 2
Number of plugs : 2
Alternator : Black to ground = 4.5 ohms +-20%
External Ignition Coil :
Distance between fixation holes: 20 mm
Wire Length: 51 mm
Resistance: 6.1 ohms
Rotor Dimensions :
Interior widest diameter : 12 mm
Interior narrowest diameter : 12 mm
Interior length : 19 mm
Exterior Diameter: 36 mm
Fixation holes center to center: 23 mm
Before installing your new Stator
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Our stator might have a different wire color code than your original part.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible but no less than 0.010".
External Ignition Coil :
Remove spark plug cap(s) from your OEM external ignition coil. Screw cap(s) on the new external ignition coil.
Direct replacement to your original unit
Remove the yellow wire from the external ignition coil, if it is not applicable to your model.
Brand new aftermarket stator + rotor + ignition coil
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- All products shipped are tested
*All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.
Stator :
- Highest grade of lamination materials
- Highest grade of copper winding, resistant to 200 degrees Celsius
- Connector included
- Rubber grommet included