30300-HA0-003
30300-HA0-010
30300-HA0-013
30300-HA0-023
30300-HA0-033
30300-HA7-671
31120-HC4-004
31120-HC4-014

Dimensions:
Height: 31 mm
Length: 20 mm
Width: 22 mm
Bracket center to center: 35 mm

Wire to wire resistance:
Pin to Ground = 350 ohms+/-20%

Not following these instructions may result in damaging the part or other components on your vehicle.

By using a small soldering iron weld the wires to the ones on your OEM wiring harness.
Insulate your solders with heat shrink.
Before attempting to start your vehicle, adjusting the air gap is necessary for certain models.
Rotate the fly wheel by hand so the raised node is lined up with the pick up /pulsar coil and adjust as close as possible, but no less than 0.010’’.
If no spark or erratic spark, switch the wires at the plug.

*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Stator Pickup Pulsar Coil for Honda ATC 125 200 250 FL 400R TRX 125 200 250 300 350 400 450 500 650 1985-2021