Stator Pickup Pulsar Coil for Yamaha Apex 1000 GT RTX Mountain MTX LTX / Attak 1000 GT 2006-2010
Height: 20 mm
Length: 20 mm
Width: 20 mm
Bracket center to center: 35 mm
Wires length : 700 mm
Number of wires : 2
Number of pins: 2
Wire to wire resistance:
Black to White = 500 ohms +/-20%
Not following these instructions may result in damaging the part or other components on your vehicle.
- By using a small soldering iron weld the wires to the ones on your OEM wiring harness.
- Insulate your solders with heat shrink.
- Before attempting to start your vehicle, adjusting the air gap is necessary for certain models.
- Rotate the flywheel by hand so the raised node is lined up with the pick up /pulsar coil and adjust as close as possible, but no less than 0.010''.
- If no spark or erratic spark, switch the wires at the plug.
Brand new pick up coil for Stator 500 ohms
- We offer a brand new pickup/pulsar coil for you to repair your stator.
- Often unavailable from the OEM manufacturer
- All products shipped are tested
*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.