High Output Performance Stator 200 W + AC Regulator for Yamaha YFZ 350 Banshee 1995-2006

CAD$ 339.00
Availability: In stock
SKU
RM01034

We offer as well two other stators for these models:



  • Stator 100 W without a backplate : product RM01043

  • Stator 100 W with a backplate : product RM01032

Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.

3GG-85510-00-00
3GG-85510-01-00
Dimensions :
Interior diameter : 103mm
Exterior diameter : 34mm
Thickness : 27mm
Length of wires stator to grommet : 60mm
Length of wires grommet to plug : 520mm
Length of pickup coil's wire to grommet : 80mm

Other specifications :
Number of wires : 6
Number of plugs : 3
Number of pins : 6

Wire to wire resistance :
Alternator : Yellow to Black = 0.4ohms +/-20%
Pickup : White/Green to White/Red = 115ohms +/-20%
Source : Green to Red = 12ohms +/-20%

Dimensions AC Regulator:
Height: 20 mm
Length: 45 mm
Width: 45 mm

Other specifications:
Number of terminals: 2
Wires length: 130 mm

Before installing your new stator
  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulator/rectifier
  • Check and repair any melted wiring.
  • Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.

When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".

Check to be sure that all of the following is done to ensure that your AC regulator rectifier is installed properly:

  • Bolt regulator to frame
  • Ground Black wire to Frame or Harness ground
  • Connect yellow wire to AC output lead of the Stator

Brand New High Output Aftermarket Stator 200W

  • Direct replacement to your original unit
  • Plug-and-play, direct fit, easy installation.
  • Highest grade lamination materials
  • Highest grade copper windings, resistant to 200 degrees Celsius.
  • Pick up pulsar coil included
  • Connector included
  • Rubber grommet included
  • Back Plate included
  • All products shipped are tested

20% MORE OUTPUT OVER STOCK, WORKS WITH ALL OTHER OEM COMPONENTS.

All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

For a limited time we are including a FREE Tympanum AC regulator required to run the extra wattage supplied from our 200W stator.

  • AC Regulator
  • 12 Volts regulator used by Baja winners
  • For use with all standard halogen and quartz lights
  • Precise voltage control, eliminates light burnout
  • Reduce flickering and dimming
  • Simple installation
  • Works with all other OEM parts
  • Rated at 225 watts.
Write Your Own Review
You're reviewing:High Output Performance Stator 200 W + AC Regulator for Yamaha YFZ 350 Banshee 1995-2006
Your Rating
Customers Also Viewed
Currently there is no product to display.