Generator Stator for Yamaha XV 700 Virago XV 750 Virago XV 1100 Virago 1986-1999
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 1999 Yamaha Virago XV 1100
- 1998 Yamaha Virago XV 1100
- 1997 Yamaha Virago XV 750
- 1997 Yamaha Virago XV 1100
- 1996 Yamaha Virago XV 750
- 1996 Yamaha Virago XV 1100
- 1995 Yamaha Virago XV 750
- 1995 Yamaha Virago XV 1100
- 1994 Yamaha Virago XV 750
- 1994 Yamaha Virago XV 1100
- 1993 Yamaha Virago XV 750
- 1993 Yamaha Virago XV 1100
- 1992 Yamaha Virago XV 750
- 1992 Yamaha Virago XV 1100
- 1991 Yamaha Virago XV 750
- 1991 Yamaha Virago XV 1100
- 1990 Yamaha Virago XV 750
- 1990 Yamaha Virago XV 1100
- 1989 Yamaha Virago XV 750
- 1989 Yamaha Virago XV 1100
- 1988 Yamaha Virago XV 750
- 1988 Yamaha Virago XV 1100
- 1987 Yamaha Virago XV 700
- 1987 Yamaha Virago XV 1100
- 1986 Yamaha Virago XV 700
- 1986 Yamaha Virago XV 1100
1TA-81410-20-00
4PP-81410-00-00
Dimensions :
Interior diameter : 53 mm
Exterior diameter : 114 mm
Thickness : 17 mm
Length of wires stator : 700 mm
Other specifications :
Number of wires : 4
Number of pins : 4
Wire to wire resistance :
Alternator : White between each White = 0.4 ohms +/-20%
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Brand new stator
- You must re-install your original grommet and the new connector (see picture).
- Once your connector and grommet is re-installed, our part becomes a Plug-and-play unit, direct fit, and very easy to install.
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Connector included
- All product shipped are tested
We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues.
*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.