Stator for Kawasaki Ninja ZX-12 R 2002 2003
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
21003-1391
Interior diameter : 41 mm
Exterior diameter : 103 mm
Thickness : 21 mm
Length of wires stator to grommet : 45 mm
Length of wires grommet to plug : 800 mm
Other specifications :
Number of wires : 4
Number of plugs : 1
Number of pins : 3
Wire to wire resistance :
Alternator : Black/Red To Black/Red = 0.4 ohms +/-20%
Alternator : Black To Ground = O.L on display +/-20%
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Brand new aftermarket stator
- Direct replacement to your original unit
- Higher grade of electric components.
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Connector included
- Grommet included
- All products shipped are tested
We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues.
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.