Stator for Yamaha Venture 500 / V-Max 500 XT XTC / V-Max 600 SX SXS XT XTC XTR / SX 500 R 1997-2001 | 8CR-85510-01-00
In 1999, this stator only fits the VMAX 600 (VX600C). For 1999 VMAX 600 Deluxe (VX600ERC) & VMAX 600 SX (VX600SX), the right stator is RM01132.
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2001 Yamaha Venture 500
- 2001 Yamaha V-Max 500
- 2001 Yamaha SX 500 R
- 2000 Yamaha Venture 500
- 2000 Yamaha V-Max 500
- 2000 Yamaha SX 500 R
- 1999 Yamaha Venture 500
- 1999 Yamaha V-Max 500
- 1998 Yamaha Venture 500
- 1998 Yamaha V-Max 600 SX
- 1998 Yamaha V-Max 600
- 1998 Yamaha V-Max 500
- 1997 Yamaha Venture 500
- 1997 Yamaha V-Max 600 SX
- 1997 Yamaha V-Max 600
- 1997 Yamaha V-Max 500
8CR-85510-01-00
Interior diameter : 41 mm
Exterior diameter : 103 mm
Thickness : 13 mm
Length of wires stator to grommet : 85 mm
Length of wires grommet to plug : 200 mm
Length of pickup coil's wire to grommet : 100 mm
Other specifications :
Number of wires : 8
Number of plugs : 2
Number of pins : 8
Wire to wire resistance :
Alternator : Yellow/Brown to Yellow = 0.4 ohms +/-20%
Pickup : White/Green to White/Red = 200 ohms +/-20%
Source : Red/Black to Brown = 320 ohms +/-20%
Other : Black to White = 0.3 ohms +/-20% (coil is grounded)
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Brand new stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation.
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Pick up pulsar coil included
- Connector included
- Rubber grommet included
- All product shipped are tested
*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.