Generator Stator for Can-Am Spyder GS Roadster 990 Spyder RS Roadster 990 Spyder RS-S Roadster 990 2008-2013
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2013 Can-Am Spyder RS-S Roadster 990 SM5
- 2013 Can-Am Spyder RS-S Roadster 990 SE5
- 2013 Can-Am Spyder RS Roadster 990 SM5
- 2013 Can-Am Spyder RS Roadster 990 SE5
- 2012 Can-Am Spyder RS-S Roadster 990 SE5
- 2012 Can-Am Spyder RS Roadster 990 SE5
- 2011 Can-Am Spyder RS Roadster 990 SE5
- 2010 Can-Am Spyder RS-S Roadster 990 SE5
- 2010 Can-Am Spyder RS Roadster 990 SE5
- 2009 Can-Am Spyder RS Roadster 990 SE5
- 2009 Can-Am Spyder GS Roadster 990 SE5
- 2008 Can-Am Spyder GS Roadster 990 SE5
Dimension :
Interior diameter = 54 mm
Exterior diameter = 115 mm
Width = 25 mm
Other specifications :
Number of wires = 3
Number of plug = 1
Number of terminals = 3
Harness length Stator to grommet = 140 mm
Harness length grommet to plug = 780 mm
Wire to wire resistance :
Alternator : Yellow between each Yellow = 0.5 ohms +/- 20%
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original. `
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010’’.
Brand new generator stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation.
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Connector included
- Rubber grommet included
- All product shipped are tested
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.