Generator Stator for Triumph Speed Triple 1050 2005-2010
This part is compatible with Triumph Speed Triple (1994-2018) models with the following details:
- VIN: 141872 to 210444 (Engine number: 183487 or higher)
- VIN: 210445 to 461331 (Engine number: 356142 or lower)
For other VINs and Engine numbers:
- VIN: 141872 to 210444 (Engine number lower than 183486) - refer to OEM T1300502
- VIN: 210445 to 461331 (Engine number higher than 356143) - refer to OEM T1300111
- VIN: 461332 to 735437 - refer to OEM T1300111
- VIN: lower than 141871 - refer to OEM T1300350
Please Note: There are 2 possible stators for the models Triumph Speed Triple 1050 2005-2010. Compare the dimension of your original product with the dimension of our product before buying.
The dimensions for this stator are:
- Exterior diameter: 104 mm
- Interior diameter: 42 mm
- Thickness: 26 mm
T1300610
Dimensions:
Interior diameter: 42 mm
Exterior diameter: 104 mm
Thickness: 26 mm
Harness length to grommet: 113 mm
Harness length grommet to plug: 820 mm
Other specifications:
Number of wires:3
Number of plugs: 1
Number of pins: 3
Wire to wire resistance:
Alternator: Between each Black = 0.4 ohms +/-20%
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original. `
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010’’.
Warning:
Risk of electric shock. Disconnect the battery before servicing.
Ensure proper installation by a qualified technician to avoid malfunction.
Brand new generator stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation.
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Connector included
- Rubber grommet included
- All products shipped are tested
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.