Generator Stator for Kawasaki Jet Ski 900 1100 ZXI / 900 1100 STX 1995-2003
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2003 Kawasaki 1100 Zxi
- 2002 Kawasaki 1100 Zxi
- 2001 Kawasaki 1100 Zxi
- 2000 Kawasaki 1100 Zxi
- 1999 Kawasaki 1100 Zxi
- 1998 Kawasaki Jet Ski 900 STX
- 1998 Kawasaki 1100 Zxi
- 1998 Kawasaki 1100 STX
- 1997 Kawasaki Jet Ski 900 STX
- 1997 Kawasaki 900 ZXi
- 1997 Kawasaki 1100 Zxi
- 1997 Kawasaki 1100 STX
- 1996 Kawasaki 900 ZXi
- 1996 Kawasaki 1100 Zxi
- 1995 Kawasaki 900 ZXi
Dimensions :
Interior diameter : 42 mm
Exterior diameter : 104 mm
Thickness : 15.5 mm
Length of wires stator to grommet : 100 mm
Length of wires grommet to plug : 1650 mm
Length of pickup coil's wire to grommet : 90 mm
Other specifications :
Number of wires : 8
Number of plugs : 2
Number of pins : 8
Wire to wire resistance :
Alternator : = Brown to Brown = 1.2 ohms +-20%
Pickup : = Green to Blue = 485 ohms +-20%
Source : = Red to Black/Red= 439 ohms +-20%
Before installing your new stator
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Brand new aftermarket stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Pick up pulsar coil included
- Connector included
- Rubber grommet included
- All products shipped are tested
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.