Kit Stator + Voltage Regulator Rectifier + Magneto Flywheel for Ski-Doo Tundra 280 R Tundra 250 II 1998-2005

CAD$ 631.00
Availability: In stock


WARNING :Ski-Doo Tundra R 1999-2005 models ; This stator has a different visual configuration than the OEM equipment, but works perfectly and exactly as a replacement part to your OEM stator.


Dimensions :
Interior diameter : 43 mm
Exterior diameter : 110 mm
Thickness : 32 mm
Length of wires stator to grommet : 500 mm

Other specifications :
Number of wires : 7
Number of plugs : 2
Number of pins : 7

Wire to wire resistance :
Alternator : Yellow to Yellow = 0.4 ohms +/-20%
Alternator : Yellow to Ground = 0.L Source : Red to Black = 80 ohms +/-20%

Voltage Regulator Rectifier

Width: 41 mm
Length: 41 mm
Height: 21 mm
Wires length: 95 mm
Fixation hole center to edge: 20 mm

Other specifications:
Number of plugs: 1
Number of pins: 3
Number of wires: 4


Exterior Diameter: 117 mm
Interior Diameter: 96 mm
Interior Diameter Center Housing: 24 mm
Exterior Diameter Center Housing: 35 mm
Thickness (exterior): 46 mm
Thickness (interior): 23 mm

Before installing your new Stator and Voltage Regulator Rectifier

  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulator/rectifier
  • Check and repair any melted wiring.
  • Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible but no less than 0.010".


Before attempting to start your Ski-Doo Tundra 300, adjusting the air gap is necessary. Rotate the flywheel so the raised node is lined up with the pick up/pulser coil and adjust as close as possible but no less than 0.010".

Brand New Magneto Flywheel + Stator + Voltage Regulator Rectifier Kit

  • Direct replacement to your original unit
  • Plug-and-play, direct fit, easy installation
  • All products are tested

All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.

  • Highest grade of lamination materials
  • Highest grade of copper winding, resistant to 200 degrees Celsius
  • Back Plate included
  • Connector included
Voltage Regulator Rectifier
  • No assembly required
  • Higher grade of electric components
  • The quality exceeds the OEM equipment
Write Your Own Review
You're reviewing:Kit Stator + Voltage Regulator Rectifier + Magneto Flywheel for Ski-Doo Tundra 280 R Tundra 250 II 1998-2005
Your Rating
Customers Also Viewed
Currently there is no product to display.