Kit Stator 200 W + HP CDI Box + External Ignition Coil for Honda ATC 250 R 1985

• 1985 Honda ATC 250 R

RM22971-R00

High Ouptut Stator :
Interior diameter : 34mm
Exterior diameter : 88mm
Thickness : 17mm
Length of wires stator to grommet : 60mm
Length of wires grommet to plug : 60mm & 620mm
Length of pickup coil's wire to grommet : 80mm

Other specifications :
Number of wires : 4
Number of plugs : 3
Number of pins : 4

Wire to wire resistance :
Alternator : White to Ground = 0.4 ohms +/-20%
Pickup : Green to Blue = 115 ohms +/-20%
Source : Black/Red to Ground = 210 ohms +/-20%

CDI Box
Height: 23mm
Length: 65mm
Width: 37mm

Other specifications:
Number of plugs: 1
Number of pins: 6

The only real way to test your CDI box is to swap it out with another known good unit from the same year/make/model. Because of this, we recommend that you rule everything else out before replacing the CDI box.

Before installing your new stator:

• Check the AC output of the stator.
• Replace any burned or corroded connectors on stator and regulator/rectifier
• Check and repair any melted wiring.
• Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code then youﾒre original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010ﾒﾒ.

CDI Box
Our CDI may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This CDI is designed as a direct plug-in replacement and should be used as such.

External ignition coil
Remove the yellow wire from the external ignition coil, if it is not applicable to your model.