Kit High Output Stator + High Performance CDI Box for Honda TRX 250 R 1988-1989
Interior diameter : 34mm
Exterior diameter : 88mm
Thickness : 17mm
Length of wires stator to grommet : 60mm
Length of wires grommet to plug : 60mm & 620mm
Length of pickup coil's wire to grommet : 80mm
Other specifications :
Number of wires : 4
Number of plugs : 3
Number of pins : 4
Wire to wire resistance :
Alternator : White to Ground = 04.4 ohms +/-20%
Pickup : Green to Blue = 115 ohms +/-20%
Source : Black/Red to Ground = 210 ohms +/-20%
CDI Box
Height: 25mm
Length: 80mm
Width: 49mm
Other specifications:
Number of plugs: 2
Number of pins: 6
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code then youﾒre original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010ﾒﾒ.
Our CDI may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This CDI is designed as a direct plug-in replacement and should be used as such.
Brand New Kit High Output 200W Stator + High Performance CDI Box
- Direct replacement to your original unit
- All shipped products are tested
*All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.
High output stator 200 watts- Highest grade of lamination materials
- Highest grade of copper winding, resistant to 200 degrees Celsius
- Pick up pulsar coil included
- Connector included
- Rubber grommet included
- Back Plate included
- Enhanced timing curve, increased rev limiter (approximately 1000 rpm)
- Higher grade of electronic components
- The Quality exceeds the OEM equipment