Kit Stator + Regulator Rectifier + High Performance CDI Box + External Ignition Coil for Yamaha YFM 400 Kodiak 2000 2001
Stator Dimensions
Interior diameter : 53 mm
Exterior diameter : 115 mm
Thickness : 16 mm
Length of wires stator to grommet : 160 mm
Length of wires grommet to plug : 460 mm
Length of pickup coil's wire to grommet : 110 mm
Other specifications :
Number of wires : 7
Number of plugs : 2
Number of pins : 7
Wire to wire resistance :
Alternator : Between each White = 0.4 ohms +/-20%
Pickup : Green to Blue = 440 ohms +/-20%
Source : Red to Blue/White = 0.2 ohms +/-20%
Regulator Dimensions
Height: 84 mm
Length: 79 mm
Width: 25 mm
Other specifications:
Number of plugs: 1
Number of pins : 6
Bracket center to center: 60 mm
CDI Box Dimensions
Height : 27 mm
Length : 110 mm
Width : 78 mm
Distance between fixations holes : 126 mm
Other specifications:
Number of plugs : 2
Number of pins : 10
External ignition coil Dimensions
Distance between fixation holes: 55 mm
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
High performance CDI Box
Our CDI may use a different wire color code than your original part.
External ignition coil
Remove the yellow wire from the external ignition coil, if it is not applicable to your model.
Kit Stator + Voltage Regulator Rectifier + High performance CDI Box + External ignition coil
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- The Quality exceeds the OEM equipment
- All shipped products are tested
All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.
Stator- Highest grade of lamination materials
- Highest grade of copper winding, resistant to 200 degrees Celsius
- Pick up pulsar coil included
- Connector included
- Rubber grommet included
We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues.
Voltage regulator rectifier- Improved heat sink and charging capabilities
- Higher grade of electric components
- Enhanced timing curve, increased rev limiter (approximately 1000 rpm)
- Higher grade of electronic components
- Spark plug cap(s) included