Stator for Aprilia SL 750 900 Shiver 2007-2018 GT | SMV 750 900 1200 Dorsoduro 2008-2018 | OEM Repl.# 640168
Battery condition is important. No stator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. ALWAYS START WITH A FULLY CHARGED BATTERY !
- 2018 Aprilia SMV 900 Dorsoduro
- 2018 Aprilia SL 900 Shiver
- 2017 Aprilia SMV 900 Dorsoduro
- 2017 Aprilia SL 900 Shiver
- 2016 Aprilia SMV 750 Dorsoduro America
- 2016 Aprilia SMV 750 Dorsoduro
- 2016 Aprilia SMV 1200 Dorsoduro
- 2016 Aprilia SL 750 Shiver Europe
- 2016 Aprilia SL 750 Shiver America
- 2015 Aprilia SMV 750 Dorsoduro America
- 2015 Aprilia SMV 750 Dorsoduro
- 2015 Aprilia SMV 1200 Dorsoduro
- 2015 Aprilia SL 750 Shiver Europe
- 2015 Aprilia SL 750 Shiver America
- 2015 Aprilia SL 750 Shiver
- 2014 Aprilia SMV 750 Dorsoduro
- 2014 Aprilia SMV 1200 Dorsoduro
- 2014 Aprilia SL 750 Shiver Europe
- 2014 Aprilia SL 750 Shiver America
- 2013 Aprilia SMV 750 Dorsoduro Factory
- 2013 Aprilia SMV 750 Dorsoduro
- 2013 Aprilia SMV 1200 Dorsoduro
- 2013 Aprilia SL 750 Shiver Europe
- 2013 Aprilia SL 750 Shiver America
- 2012 Aprilia SMV 750 Dorsoduro Factory
- 2012 Aprilia SMV 750 Dorsoduro
- 2012 Aprilia SMV 1200 Dorsoduro
- 2012 Aprilia SL 750 Shiver Europe
- 2012 Aprilia SL 750 Shiver America
- 2011 Aprilia SMV 750 Dorsoduro Factory
- 2011 Aprilia SMV 750 Dorsoduro
- 2011 Aprilia SMV 1200 Dorsoduro
- 2011 Aprilia SL 750 Shiver Europe
- 2011 Aprilia SL 750 Shiver America
- 2010 Aprilia SMV 750 Dorsoduro Factory
- 2010 Aprilia SMV 750 Dorsoduro
- 2010 Aprilia SMV 1200 Dorsoduro
- 2010 Aprilia SL 750 Shiver Europe
- 2009 Aprilia SMV 750 Dorsoduro
- 2009 Aprilia SL 750 Shiver GT
- 2009 Aprilia SL 750 Shiver
- 2008 Aprilia SMV 750 Dorsoduro
- 2008 Aprilia SL 750 Shiver
- 2007 Aprilia SL 750 Shiver
Dimensions :
Interior diameter : 54 mm
Exterior diameter : 118 mm
Thickness : 19 mm
Length of wires stator to grommet : 110 mm
Length of wires grommet to plug : 520 mm
Length of pickup coil's wire to grommet : 10 mm
Other specifications :
Number of wires : 5
Number of plugs : 2
Number of pins : 5
Number of poles : 18
Wire to wire resistance :
Alternator : Between each Yellow = 0.4 ohms +-20%
Pickup : Yellow / White to Yellow / Blue = 272 ohms +-20%
Before installing your new Stator
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Our stator might have a different wire color code than your original part.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible but no less than 0.010".
Brand new aftermarket Stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- Highest grade of lamination materials
- Highest grade of copper winding, resistant to 200 degrees Celsius
- Pick up pulsar coil included
- Connectors included
- Rubber grommet included
- All products shipped are tested
We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause of repetitive electrical issues.
All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.