Generator Stator for Triumph Street Triple 660 S | Street Triple 675 / R | Street Triple 765 R / RS / S 2007-2020

CAD$ 244.00
Availability: In stock
SKU
RMS010-106948

Please note That there are multiple possible stators for the 2007 to 2018 Street Triple. This stator will only fits on :




Street Triple Standard This part will only fit Street triple Standard with a VIN HIGHER than 560477 and with an engine number LOWER than 616232 or BETWEEN 624373 and 626866. If your vehicle has a VIN LOWER than 354281, please refer to RM01348. If If your vehicle has a VIN BETWEEN 354282 and 560476, please refer to RM01389. If your vehicle has a VIN higher than 560477 and an engine number between 616233 and 624372 or higher than 626867, refer to RMS010-107391.




Street Triple R 2008 to 2020 This part will only fit Street triple R with a VIN HIGHER than 45677 and an engine # LOWER than 616232 or Higher than 624373 . For vehicle with a VIN LOWER than 560476, refer to RM01389. For vehicle with a VIN HIGHER than 560477 and an engine # BETWEEN 616233 and 624372, refer to OEM T1303139..



Please always refer to our photos to make sure you buy the right part for your needs.

Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.



Stator failure on these Triumph motorcycles often affect the voltage regulator at a point where the defective voltage regulator will cause any new stator installed to fail prematurely. We highly recommend to replace your current voltage regulator with our voltage regulator RMS022-105928. Where RMS900-107277 is the kit that fit the models.

T1300057
T1300205

Dimensions :
Interior diameter : 42 mm
Exterior diameter : 115 mm
Thickness : 16 mm
Length of wires stator to grommet : 250 mm
Length of wires grommet to plug # 1 : 195 mm
Length of wires grommet to plug # 2 : 500 mm
Length of pickup coil's wire to grommet : 280 mm

Other specifications :
Number of wires : 5
Number of plugs : 2
Number of pins : 5
Number of poles : 18

Wire to wire resistance :
Alternator : Between each Black = 0.6 ohms +-20%
Pickup : Green To Grey = 244 ohms +-20%

Before installing your new Stator

  • Check the AC output of the stator
  • Replace any burned or corroded connectors on stator and regulator rectifier
  • Check and repair any melted wiring
  • Use hi-temp dielectric grease on all connectors

Our stator might have a different wire color code than your original part.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible but no less than 0.010".

Brand new aftermarket Stator

  • Direct replacement to your original unit
  • Plug-and-play, direct fit, easy installation
  • Pick up pulsar coil included
  • Connectors included
  • Rubber grommet included
  • All products shipped are tested

We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause of repetitive electrical issues.

All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.

Write Your Own Review
You're reviewing:Generator Stator for Triumph Street Triple 660 S | Street Triple 675 / R | Street Triple 765 R / RS / S 2007-2020
Your Rating
Customers Also Viewed
Currently there is no product to display.