Stator Source Coil for Yamaha Y-Zinger PW80 1983-1985 1991-1994 | Big Wheel BW80 1986-1987 OEM # 1RY-85512-20-00
Specifications:
Number of wires: 2
Number of terminals : 2
Number of plug: 2
Distance between fixation holes: 48 mm
Read these instructions completely before beginning:
Step 1 : Take the ignition cover off. Are the remplacement parts similar? Compare the replacement part to the original. The remplacement part should match, including the mounting hole locations, If not: Double check the application listing with your bike.
Step 2 :Take note of the wire colors of the original stator wires and disconnect them from the wiring loom.
Step 3: Remove the flywheel using a proper puller tool.
Step 4: Remove the baseplate with the original coil.
Step 5: Remove the screws that secure the coil and take the coil off.
Step 6: Cut the original wire close to the original coil. Take a good look at how the wire is connected to the coil. Connections: Connect the old wire up to the new coil. Use a soldering iron and resin core solder. (the type used in electrical applications
Step 7: Mount the coil onto the baseplate, fit the screws using locking compound on the threads and TIGHTEN THE SCREWS SECURELY! Step 8: Refit the stator baseplate. Ensure the wires CAN NOT TOUCH THE FLYWHEEL! (especially on the inside of the flywheel)
Step 9: Refit the flywheel. Tighten the bolt to specified torque.
Step 10: Fit the ignition cover.
TROUBLESHOOTING:
Engine will not start: Sometimes the source coil wires are reversed. Swap the connections, re-solder the wires and the engine should start. If the engine still does not start, and before calling technical support, performs a few basic tests:
- Re-check the connections. Make sure you carefully solder the connections. Twisting wires together or taping wires will cause engine inoperability.
- Check the engine for spark.
- Is fresh fuel in the gas tank?
If you still cannot get the engine to start, have all your testing information ready for a technician prior calling.
We offer a brand new Stator Source Coil for you to repair your stator
- Often unavailable from the OEM manufacturer
- Highest grade of lamination materials
- Highest grade of copper winding, resistant to 200 degrees Celsius
- Works with all other OEM parts
- All products shipped are tested
All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.