Voltage Regulator Rectifier for Kawasaki Eliminator 125 1998-2007 2009 | KL 250 2000- 2004 2009 2010
Battery condition is important. No regulator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. ALWAYS START WITH A FULLY CHARGED BATTERY !
- 2010 Kawasaki KL 250
- 2009 Kawasaki KL 250
- 2009 Kawasaki Eliminator 125
- 2007 Kawasaki Eliminator 125
- 2006 Kawasaki Eliminator 125
- 2005 Kawasaki Eliminator 125
- 2004 Kawasaki KL 250
- 2004 Kawasaki Eliminator 125
- 2003 Kawasaki KL 250
- 2003 Kawasaki Eliminator 125
- 2002 Kawasaki KL 250
- 2002 Kawasaki Eliminator 125
- 2001 Kawasaki KL 250
- 2001 Kawasaki Eliminator 125
- 2000 Kawasaki KL 250
- 2000 Kawasaki Eliminator 125
- 1999 Kawasaki Eliminator 125
- 1998 Kawasaki Eliminator 125
Dimensions:
Width: 41 mm
Length: 75 mm
Height: 26 mm
Distance between fixation holes center to center: 69 mm
Other specifications:
Number of plugs: 1
Number of pins: 4
Minimum Charging Voltage: 14.5 V +- 0.5 V
Maximum Charging Current: 50 A / 500 W
Open Circuit Voltage: < 15 V
Operation Temperature: -20°C to 85°C
Before installing your new Voltage Regulator Rectifier:
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Brand new aftermarket Voltage Regulator Rectifier
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- No assembly required
- Higher grade of electric components
- Improved heat sink and charging capabilities
- The quality exceeds the OEM equipment
- All products shipped are tested
We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and are a major cause of repetitive electrical issues.
All item pictures are accurate, if in doubt, do not hesitate and compare our item to your original part.