Kit Stator + CDI Box + Gasket for Honda TRX 450 R 2004-2005 TRX450R

• 2005 Honda TRX 450 R
• 2004 Honda TRX 450 R

STATOR Dimensions :
Interior diameter : 34 mm
Exterior diameter : 92 mm
Thickness : 15 mm
Length of wires stator to grommet : 75 mm
Length of wires grommet to plug : 900 mm
Length of pickup coil's wire to grommet : 80 mm

Other specifications :
Number of wires : 8
Number of plugs : 3
Number of pins : 8
Number of poles : 17

Wire to wire resistance :
Alternator 3p : Between each Yellow = 0.4 ohms +-20%
Alternator 1p: Yellow to ground = O.L
Pickup : Green to Blue = 250 ohms +-20%
Source #1: Black/Red to Blue = 36 ohms +-20%
Source #2: Blue to White = 7 ohms +-20%

CDI BOX Dimensions:
Height: 26 mm
Length: 75 mm
Width: 70 mm

Other specifications:
Number of plugs: 2
Number of pins: 14

Please note that: The only real way to test your CDI box is to swap it out with another known good unit from the same year / make / model. Because of this, we recommend that you rule everything else out before replacing the CDI box.

Before installing your new Stator

• Check the AC output of the stator
• Replace any burned or corroded connectors on stator and regulator rectifier
• Check and repair any melted wiring
• Use hi-temp dielectric grease on all connectors

Our stator might have a different wire color code than your original part.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible but no less than 0.010".

Before installing your new CDI Box

Our CDI might have a different wire color code than your original part.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This CDI is designed as a direct plug-in replacement and should be used as such.