SPLYT Supercharged Technology Stator + Regulator + High Output Flywheel for Polaris Ranger | RZR | Sportsman 2013-2018

This charging upgrade provides a tremendous 900W output to allow you to install accessories without draining the original battery nor installing a secondary battery. This upgrade installs seamlessly freeing the space a second battery would take on your ride.

CAD$ 879.00
Availability: In stock
SKU
RMS900-106951
106951-R00

Dual Stator Dimensions
Interior diameter : 53 mm
Exterior diameter : 125 mm
Thickness : 26 mm
Length of wires stator to grommet : 125 mm
Length of wires grommet to plug : 290 mm & 550 mm

Other specifications :
Number of wires : 6
Number of plugs : 2
Number of pins : 6
Number of poles : 18

Wire to wire resistance :
Alternator: Yellow/Black to Yellow/Black = 0.5 ohms +-20%

Regulator Dimensions
Width: 84 mm
Length: 90 mm
Height: 32 mm
Fixation holes center to center: 69 mm

Other specifications:
Number of plugs: 2
Number of pins: 5
Minimum Charging Voltage: 14.5 V +- 0.5 V
Maximum Charging Current: 50 A / 500 W
Open Circuit Voltage: < 15 V
Operation Temperature: -20º to 85º

Relocation Harness Dimensions
Wires length : 3400 mm
Number of yellow wires : 3
Number of red wires : 1
Number of black wires : 1
Number of plugs : 2

Flywheel Dimensions
Exterior Diameter: 140.6 mm
Interior Diameter: 127.8 mm
Interior Diameter Center Housing: 22.4 mm
Exterior Diameter Center Housing: 50 mm
Thickness (exterior): 49.3 mm
Thickness (interior): 38.7 mm

Diameter of the Shaft largest to the narrowest:

  • 37.4 mm
  • 27.8 mm
  • 22.4 mm
Download our complete installation instruction (PDF 15Mo)

Before installing your new stator

  • Check the AC output of the stator
  • Replace any burned or corroded connectors on stator and regulator rectifier
  • Check and repair any melted wiring
  • Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".

Before installing your new Mosfet Voltage Regulator Rectifier

  • Check the AC output of the stator
  • Replace any burned or corroded connectors on stator and regulator rectifier
  • Check and repair any melted wiring
  • Use hi-temp dielectric grease on all connectors

Before installing your new Flywheel

Before attempting to start your (INSERT BRAND NAME), adjusting the air gap is necessary. Rotate the flywheel so the raised node is lined up with the pick up/pulser coil and adjust as close as possible but no less than 0.010".

Relocation Harness

  • Plug-and-Play, direct fit
  • Use hi-temp dielectric grease on all connectors.
  • Watch our installation video.

    Why use the SPLYT Technology?

    As featured by Dirt Trax Television, RMSTATOR SPLYT Technology provides a reliable solution to well-known charging system failures. Using a dual output stator with two completely separate stator windings, this system splits the power generated by the stator into two separate voltage regulators. These regulators then each operate with only half of the load of the original system, allowing them to maintain a lower temperature and increase reliability.

     

    SERIES Voltage Regulation

    This system uses a new type of voltage regulator called a SERIES regulator. Rather than shunting excess power to ground like a typical regulator, it protects the battery from high voltage by disconnecting the stator coils from the regulator and preventing current from passing on. This type of voltage regulation generates less heat because current from the stator is prevented from flowing through the regulator.

     


    Ultimate reliability

    With a stock charging system, voltage regulators are consistently operating within 5% of their maximum capacity, leading to heat and stress related failure. With the RMSTATOR SPLYT system, both SERIES voltage regulators are operating with 40% overhead for long life and stable output.


    Better design

    Contrary to the original OEM stator that uses one three phase stator winding, the SPLYT stator contains two completely separate three-phase coil windings. Each of these two windings then produces half of the power of the stock stator lowering the temperature in each individual coil.

    More available power

    If you are installing a lot of accessories and electronics on your vehicle, like extra lighting, stereos or a winch,
    the SPLYT kit is available with an improved flywheel designed to increase power output from 650 Watts to 900 Watts.

     


    Easy to install

    All parts use a Plug-and-Play design, just like the original OEM ones, so no special tool or knowledge is needed to install this system.


    Harnesses included

    Relocation wiring harnesses allow to relocate the regulators anywhere on your vehicle to get better air flow and easier access.

    This kit includes:

    • Dual output stator
    • Two SERIES voltage regulators
    • Improved high output flywheel
    • Two automotive grade relocation wiring harnesses with OEM-quality heavy-duty connectors
    • Gasket
    • Complete instructions for voltage regulator relocation

    Solve your Polaris RZR & Sportsman charging system issues today, once and for all, with RMSTATOR!

    IMPORTANT NOTICE: This kit includes two wiring harness according to Polaris recal # Z-16-01-C (OEM # 2206620, 2206367,2206473). We strongly suggest you to relocate both of your regulators to make sure they do not wear out prematurely due to mud, dust or rocks.

    All item pictures are accurate, matching exactly what you will receive.

    Write Your Own Review
    You're reviewing:SPLYT Supercharged Technology Stator + Regulator + High Output Flywheel for Polaris Ranger | RZR | Sportsman 2013-2018
    Your Rating
    Customers Also Viewed
    Currently there is no product to display.