Stator for Kawasaki Jet Ski 650 X-2 JF650 / TS Tandem Sport JF650 1991-1996
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 1996 Kawasaki Jet Ski 650 TS Tandem Sport
- 1995 Kawasaki Jet Ski 650 X2
- 1995 Kawasaki Jet Ski 650 TS Tandem Sport
- 1994 Kawasaki Jet Ski 650 X2
- 1994 Kawasaki Jet Ski 650 TS Tandem Sport
- 1993 Kawasaki Jet Ski 650 X2
- 1993 Kawasaki Jet Ski 650 TS Tandem Sport
- 1992 Kawasaki Jet Ski 650 X2
- 1992 Kawasaki Jet Ski 650 TS Tandem Sport
- 1991 Kawasaki Jet Ski 650 TS Tandem Sport
21003-3716
21003-3718
Dimensions :
Interior diameter : 34 mm
Exterior diameter : 95 mm
Thickness : 13 mm
Length of wires stator to grommet 1 : 20 mm
Length of wires grommet 1 to grommet 2 : 1050 mm
Length of wires grommet 2 to plug : 75 mm
Other specifications :
Number of wires : 4
Number of plugs : 4
Number of pins : 4
Wire to wire resistance :
Alternator : Brown to Brown = 2.0 ohms +-20%
Source : Purple to Black/Yellow = 320 ohms +-20%
Before installing your new stator
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Brand new aftermarket stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Connector included
- Rubber grommet included (2)
- Back Plate included
- All products shipped are tested
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.