Stator for Yamaha YZ 65 2018 2020 | YZ 85 2002-2020 | Repl.# 5PA-85560-00-00 / 5PA-85560-01-00
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2020 Yamaha YZ 85
- 2020 Yamaha YZ 65
- 2019 Yamaha YZ 85
- 2018 Yamaha YZ 85
- 2018 Yamaha YZ 65
- 2017 Yamaha YZ 85
- 2016 Yamaha YZ 85
- 2015 Yamaha YZ 85
- 2014 Yamaha YZ 85
- 2013 Yamaha YZ 85
- 2012 Yamaha YZ 85
- 2011 Yamaha YZ 85
- 2010 Yamaha YZ 85
- 2009 Yamaha YZ 85
- 2008 Yamaha YZ 85
- 2007 Yamaha YZ 85
- 2006 Yamaha YZ 85
- 2005 Yamaha YZ 85
- 2004 Yamaha YZ 85
- 2003 Yamaha YZ 85
- 2002 Yamaha YZ 85
Interior diameter : 28 mm
Exterior diameter : 60 mm
Thickness : 8 mm
Length of wires stator to grommet : 100 mm
Length of wires grommet to plug : 400 mm
Length of pickup coil's wire to stator : 59 mm
Other specifications :
Number of wires : 6
Number of plugs : 1
Number of pins : 6
Number of poles : 4
Wire to wire resistance :
Pickup : White/Green to White/Red = 300 ohms +-20%
Source Coil #1 : Green to Black = 60 ohms +-20%
Source Coil #2 : Black/Red to Green/White = 880 ohms +-20%
Before installing your new Stator
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible but no less than 0.010".
Brand new aftermarket Stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- Highest grade of lamination materials
- Highest grade of copper winding, resistant to 200 degrees Celsius
- Pick up pulsar coil included
- Connectors included
- Rubber grommet included
- Back Plate included
- All products shipped are tested
We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause of repetitive electrical issues.
All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.