Kit Stator 100 W + External Ignition Coil + Backplate + Flywheel Puller for Yamaha YFZ 350 Banshee 1995-2006
- 2006 Yamaha YFZ 350 Banshee
- 2005 Yamaha YFZ 350 Banshee
- 2004 Yamaha YFZ 350 Banshee
- 2003 Yamaha YFZ 350 Banshee
- 2002 Yamaha YFZ 350 Banshee
- 2001 Yamaha YFZ 350 Banshee
- 2000 Yamaha YFZ 350 Banshee
- 1999 Yamaha YFZ 350 Banshee
- 1998 Yamaha YFZ 350 Banshee
- 1997 Yamaha YFZ 350 Banshee
- 1996 Yamaha YFZ 350 Banshee
- 1995 Yamaha YFZ 350 Banshee
Interior diameter : 40mm
Exterior diameter : 103mm
Thickness : 17mm
Length of wires stator to grommet : 150mm
Length of wires grommet to plug : 330mm
Length of pickup coil's wire to grommet : 270mm
Other specifications :
Number of wires : 6
Number of plugs : 3
Number of pins : 3
Wire to wire resistance :
Alternator : = Yellow to Black = 0.4 ohms +/-20%
Pickup : White/Green to White/Red = 115 ohms +/-20%
Source : Green to Red = 22 ohms +/-20%
External Ignition coil
Distance between fixation holes: 90mm
Before installing your new stator :
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Before attempting to start your YAMAHA BANSHEE:
This stator is designed as a direct plug-in replacement and should be used as such.Our stator may use a different wire color code then youメre original. All of the wires are installed in the correct order; please do not change any of the wiring configurations.When bolting stator in, always use locking compound.Adjusting the air gap is necessary, rotate the flywheel so the raised node is lined up with the pick up/pulser coil and adjust as close as possible but no less than 0.010メメ.Set adjustable timing plate at zero for stock timing
Remove the yellow wire from the external ignition coil, if it is not applicable to your model.
Brand New Kit Stator + External Ignition Coil + Flywheel Puller
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- All shipped products are tested
*All item pictures are accurate, if in doubt, do not hesitate and compare our item to your original part.
High Output Stator- Highest grade of lamination materials
- Highest grade of copper winding, resistant to 200 degrees Celsius
- Pick up pulsar coil included
- Connector included
- Rubber grommet included
- Adjustable timing plate to advance and retard up to 10 degrees included
- Highest grade of lamination materials
- Spark plug cap(s) included