High Output Performance Stator 200 W + AC Regulator for Yamaha YFZ 350 Banshee 1995-2006
We offer as well two other stators for these models:
- Stator 100 W without a backplate : product RM01043
- Stator 100 W with a backplate : product RM01032
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2006 Yamaha YFZ 350 Banshee
- 2005 Yamaha YFZ 350 Banshee
- 2004 Yamaha YFZ 350 Banshee
- 2003 Yamaha YFZ 350 Banshee
- 2002 Yamaha YFZ 350 Banshee
- 2001 Yamaha YFZ 350 Banshee
- 2000 Yamaha YFZ 350 Banshee
- 1999 Yamaha YFZ 350 Banshee
- 1998 Yamaha YFZ 350 Banshee
- 1997 Yamaha YFZ 350 Banshee
- 1996 Yamaha YFZ 350 Banshee
- 1995 Yamaha YFZ 350 Banshee
3GG-85510-01-00
Interior diameter : 103mm
Exterior diameter : 34mm
Thickness : 27mm
Length of wires stator to grommet : 60mm
Length of wires grommet to plug : 520mm
Length of pickup coil's wire to grommet : 80mm
Other specifications :
Number of wires : 6
Number of plugs : 3
Number of pins : 6
Wire to wire resistance :
Alternator : Yellow to Black = 0.4ohms +/-20%
Pickup : White/Green to White/Red = 115ohms +/-20%
Source : Green to Red = 12ohms +/-20%
Dimensions AC Regulator:
Height: 20 mm
Length: 45 mm
Width: 45 mm
Other specifications:
Number of terminals: 2
Wires length: 130 mm
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Check to be sure that all of the following is done to ensure that your AC regulator rectifier is installed properly:
- Bolt regulator to frame
- Ground Black wire to Frame or Harness ground
- Connect yellow wire to AC output lead of the Stator
Brand New High Output Aftermarket Stator 200W
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation.
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Pick up pulsar coil included
- Connector included
- Rubber grommet included
- Back Plate included
- All products shipped are tested
20% MORE OUTPUT OVER STOCK, WORKS WITH ALL OTHER OEM COMPONENTS.
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.
For a limited time we are including a FREE Tympanum AC regulator required to run the extra wattage supplied from our 200W stator.
- AC Regulator
- 12 Volts regulator used by Baja winners
- For use with all standard halogen and quartz lights
- Precise voltage control, eliminates light burnout
- Reduce flickering and dimming
- Simple installation
- Works with all other OEM parts
- Rated at 225 watts.