Generator Stator for Honda Interceptor Suzuki Intruder Boulevard Marauder Yamaha Virago XT Polaris Magnum 1988-2009
Please note : there are two possible stators for Suzuki Intruder VS 800 1992-1997. This stator will only fit on models T and V. For models N / P / R / S, please look for RM01040.
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2009 Suzuki Boulevard S50 VS800
- 2009 Polaris Trail Boss 330
- 2009 Polaris Trail Blazer 330
- 2008 Suzuki Boulevard S50 VS800
- 2008 Polaris Trail Boss 330
- 2008 Polaris Trail Blazer 330
- 2007 Suzuki Boulevard S50 VS800
- 2007 Polaris Trail Boss 330
- 2006 Suzuki Boulevard S50 VS800
- 2006 Polaris Trail Boss 330
- 2006 Polaris Magnum 330 4x4
- 2005 Suzuki Boulevard S50 VS800
- 2005 Polaris Trail Boss 330
- 2005 Polaris Magnum 330 4x4
- 2005 Polaris Magnum 330 2x4
- 2005 Polaris ATP 330
- 2004 Suzuki VS 800 GL Intruder
- 2004 Suzuki Marauder
- 2004 Polaris Trail Boss 330
- 2004 Polaris Magnum 330 4x4
- 2004 Polaris Magnum 330 2x4
- 2004 Polaris ATP 330
- 2003 Suzuki VS 800 GL Intruder
- 2003 Suzuki Marauder
- 2003 Polaris Trail Boss 330
- 2003 Polaris Magnum 330 4x4
- 2003 Polaris Magnum 330 2x4
- 2002 Suzuki VS 800 GL Intruder
- 2002 Suzuki Marauder
- 2001 Suzuki VS 800 GL Intruder
- 2001 Suzuki Marauder
- 2000 Suzuki VS 800 GL Intruder
- 2000 Suzuki Marauder
- 1999 Suzuki VS 800 GL Intruder
- 1999 Suzuki Marauder
- 1998 Suzuki VS 800 GL Intruder
- 1998 Suzuki Marauder
- 1997 Suzuki VS 800 GL Intruder
- 1997 Suzuki Marauder
- 1996 Suzuki VS 800 GL Intruder
- 1995 Yamaha XT 600
- 1995 Suzuki VS 800 GL Intruder
- 1994 Yamaha XT 600
- 1994 Suzuki VS 800 GL Intruder
- 1993 Yamaha XT 600
- 1993 Suzuki VS 800 GL Intruder
- 1992 Yamaha XT 600
- 1992 Suzuki VS 800 GL Intruder
- 1991 Yamaha XT 600
- 1990 Yamaha XT 600
- 1990 Yamaha Virago 250
- 1990 Honda VTR 250 Interceptor
- 1989 Yamaha Virago 250
- 1989 Honda VTR 250 Interceptor
- 1988 Yamaha Virago 250
- 1988 Honda VTR 250 Interceptor
3087252
3089275
31120-KBV-004
31120-KV0-004
32101-45C00
32101-48E00
3TB-81410-00-00
Dimensions:
Interior diameter: 42mm
Exterior diameter: 103mm
Thickness: 16mm
Length of wires stator to connectors: 900mm
Other specifications:
Number of wires : 3
Number of terminals : 3
Wire to wire resistance:
Alternator : Yellow between each Yellow = 0.4 ohms+/-20%
Alternator : Yellow to Ground ﾠ= O.L. ON DISPLAY
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Brand new stator
- You must re-install your original grommet and the new connector (see picture).
- Once your connector and grommet is re-installed, our part becomes a Plug-and-play unit, direct fit, and very easy to install.
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- All product shipped are tested
*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.