Generator Stator for Ski-Doo Expedition Legend Skandic SWT 2007-2010 / Lynx Rave RE YETI Pro 2006-2012

• 2012 Ski-doo Skandic V 800 SWT EFI L/C
• 2012 Lynx YETI Pro V-800
• 2011 Ski-doo Skandic V 800 SWT EFI L/C
• 2011 Lynx YETI Pro V-800
• 2011 Lynx Rave RE 800 R
• 2010 Ski-doo Skandic V 800 SWT EFI L/C
• 2010 Lynx YETI Pro V-800
• 2009 Ski-doo Skandic V 800 SWT EFI L/C
• 2009 Ski-doo Skandic Tundra LT V 800 4-TEC EFI L/C
• 2009 Ski-doo Legend Trail V 800 EFI L/C
• 2009 Ski-doo Legend Touring V800
• 2009 Ski-doo Expedition V 800 TUV 4-TEC EFI L/C
• 2009 Lynx YETI V-800
• 2009 Lynx YETI Pro V-800
• 2008 Ski-doo Skandic V 800 SWT EFI L/C
• 2008 Ski-doo Expedition V 800 TUV 4-TEC EFI L/C
• 2008 Lynx YETI V-800
• 2008 Lynx YETI Pro V-800
• 2007 Ski-doo Skandic V 800 SWT EFI L/C
• 2007 Ski-doo Expedition V 800 TUV 4-TEC EFI L/C
• 2007 Lynx YETI V-800
• 2007 Lynx YETI Pro V-800
• 2006 Lynx YETI V-800

Dimensions:
Interior diameter: 41 mm
Exterior diameter: 115 mm
Thickness: 17 mm
Length of wires stator to grommet: 120 mm
Length of wires grommet to plug: 800 mm

Other specifications:
Number of wires: 3
Number of plugs: 1
Number of pins: 3

Wire to wire resistance:
Alternator: Yellow between each Yellow = 0.4 ohms +/-20%

• Check the AC output of the stator.
• Replace any burned or corroded connectors on stator and regulator/rectifier
• Check and repair any melted wiring.
• Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original. `
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible but no less than 0.010’’.