Generator Stator for Arctic Cat 350 366 400 425 450 500 / Alterra & TRV 400 450 500 / XC 450 / XR 500 2008-2019
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2023 Arctic Cat Alterra 450
- 2022 Arctic Cat Alterra 450
- 2021 Arctic Cat Alterra 450
- 2020 Arctic Cat TRV 500
- 2019 Textron Alterra 450
- 2018 Arctic Cat Alterra 500
- 2017 Arctic Cat XC 450
- 2017 Arctic Cat TRV 500
- 2017 Arctic Cat Alterra TRV 500
- 2017 Arctic Cat Alterra 500
- 2017 Arctic Cat Alterra 400
- 2017 Arctic Cat 500 Automatic
- 2016 Arctic Cat XC 450
- 2016 Arctic Cat Alterra 500
- 2016 Arctic Cat Alterra 450
- 2016 Arctic Cat Alterra 400
- 2016 Arctic Cat 500 Automatic
- 2015 Arctic Cat XR 500
- 2015 Arctic Cat XC 450
- 2015 Arctic Cat TRV 500
- 2015 Arctic Cat 500 Automatic
- 2015 Arctic Cat 450 CR
- 2015 Arctic Cat 450
- 2015 Arctic Cat 400 CR EFI L/C
- 2015 Arctic Cat 400 Automatic
- 2014 Arctic Cat XC 450
- 2014 Arctic Cat TRV 500
- 2014 Arctic Cat TRV 400
- 2014 Arctic Cat 500 Automatic
- 2014 Arctic Cat 450 CR
- 2014 Arctic Cat 450
- 2014 Arctic Cat 400 CR EFI L/C
- 2014 Arctic Cat 400 Automatic
- 2013 Arctic Cat XC 450
- 2013 Arctic Cat TRV 500
- 2013 Arctic Cat TRV 400
- 2013 Arctic Cat 500 Automatic
- 2013 Arctic Cat 450 CR
- 2013 Arctic Cat 400 CR EFI L/C
- 2013 Arctic Cat 400 Automatic
- 2012 Arctic Cat XC 450
- 2012 Arctic Cat TRV 450
- 2012 Arctic Cat TRV 400
- 2012 Arctic Cat 450
- 2012 Arctic Cat 425 CR
- 2012 Arctic Cat 350 CR
- 2011 Arctic Cat XC 450
- 2011 Arctic Cat TRV 450
- 2011 Arctic Cat TRV 400
- 2011 Arctic Cat 450
- 2011 Arctic Cat 425 CR
- 2011 Arctic Cat 366
- 2011 Arctic Cat 350 CR
- 2010 Arctic Cat TRV 400
- 2010 Arctic Cat 450
- 2010 Arctic Cat 366
- 2009 Arctic Cat TRV 400
- 2009 Arctic Cat 366
- 2008 Arctic Cat 366
3323-200
Interior diameter : 54mm
Exterior diameter : 114mm
Thickness : 18mm
Length of wires stator to grommet : 140mm
Length of wires grommet to plug : 320mm
Length of pickup coil's wire to grommet : 95mm
Other specifications :
Number of wires : 7
Number of plugs : 2
Number of pins : 7
Wire to wire resistance :
Alternator : Black between each Black = 0.4ohms +/-20%
Pickup : Blue to Green = 185 ohms +/-20%
Position Sensor : White to Yellow = 0.2ohms +/-20%
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original. `
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010’’.
Brand new generator stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation.
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Pick up pulsar coil included
- Connector included
- Rubber grommet included
- All products shipped are tested
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.