Stator for Honda NX125 Transcity NX 125 Denso 1988-1990 | 31120-KW8-902
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
31120-KW8-902
31120-KW8-901
Dimensions :
Interior diameter : 35 mm
Exterior diameter : 88 mm
Thickness : 17.8 mm
Length of wires stator to grommet : 60 mm
Length of wires grommet to plug : 380 mm
Other specifications :
Number of wires :6
Number of plugs : 3
Number of pins :6
Wire to wire resistance :
Alternator : Pink to Yellow = 0.9 ohms +-20%
Source : Black/Red to Green = 190 ohms +-20%
Before installing your new stator
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Brand new aftermarket stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Connector included
- Rubber grommet included
- All products shipped are tested
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.