Mosfet Regulator Rectifier for Aprilia Moto RSV4 1000 / RSV 1000 Tuono V4 2011-2017
Please note : When using our Aprilia MOSFET regulator on Tuono V4 applications, the larger regulator housing is a very tight fit. It may require slight cutting, grinding, or modification to the plastic mounting area to clear the larger housing and wiring harness.
Battery condition is important. No regulator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. ALWAYS START WITH A FULLY CHARGED BATTERY !
- 2020 Aprilia Tuono V4 1100
- 2020 Aprilia RSV4 RF 1000
- 2019 Aprilia RSV4 RR 1000
- 2019 Aprilia RSV4 RF 1000
- 2019 Aprilia RSV4 1100 Factory
- 2018 Aprilia Tuono V4 1100
- 2018 Aprilia RSV4 RR 1000
- 2018 Aprilia RSV4 RF 1000
- 2017 Aprilia Tuono V4 1100
- 2017 Aprilia RSV4 RR 1000
- 2017 Aprilia RSV4 RF 1000
- 2017 Aprilia RSV4 R 1000
- 2017 Aprilia RSV4 1000 Factory
- 2016 Aprilia Tuono V4 1100
- 2016 Aprilia RSV4 RR 1000
- 2016 Aprilia RSV4 RF 1000
- 2016 Aprilia RSV4 R 1000
- 2016 Aprilia RSV4 1000 Factory
- 2016 Aprilia RSV 1000 Tuono V4
- 2015 Aprilia Tuono V4 1100
- 2015 Aprilia RSV4 RF 1000
- 2015 Aprilia RSV4 R 1000
- 2015 Aprilia RSV4 1000 Factory
- 2015 Aprilia RSV 1000 Tuono V4
- 2014 Aprilia Tuono V4 1000
- 2014 Aprilia RSV4 R 1000
- 2014 Aprilia RSV4 1000 Factory
- 2014 Aprilia RSV 1000 Tuono V4
- 2013 Aprilia Tuono V4 1000
- 2013 Aprilia RSV4 R 1000
- 2013 Aprilia RSV4 1000 Factory
- 2013 Aprilia RSV 1000 Tuono V4
- 2012 Aprilia Tuono V4 1000
- 2012 Aprilia RSV4 R 1000
- 2012 Aprilia RSV4 1000 Factory
- 2012 Aprilia RSV 1000 Tuono V4
- 2011 Aprilia RSV4 R 1000
- 2011 Aprilia RSV4 1000 Factory
- 2011 Aprilia RSV 1000 Tuono V4
- 2010 Aprilia RSV4 R 1000
- 2010 Aprilia RSV4 1000 Factory
- 2009 Aprilia RSV4 R 1000
- 2009 Aprilia RSV4 1000 Factory
Dimensions:
Width: 95 mm
Length: 95 mm
Height: 28 mm
Wires length: 150 mm & 400 mm
Fixation holes center to center: 80 mm
Other specifications:
Number of plugs: 2
Number of pins: 7
Number of wires: 7
Minimum Charging Voltage: 14.5 V +- 0.5 V
Maximum Charging Current: 50 A / 500 W
Open Circuit Voltage: 15 V
Operation Temperature: -20⁰ C to 85⁰ C
Before installing your new Mosfet voltage regulator rectifier :
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulatorrectifier.
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors.
Brand new Mosfet Voltage Regulator Rectifier
STOP BURNING YOUR REGULATOR RECTIFIER !
It is time to update or replace your voltage regulator with the advanced MOSFET type.
It runs cooler than all OEM diode style regulators. In addition, this rectifier has overheat protection, rather than burn up it will simply turn off for a while and cool off.
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- The quality exceeds the OEM equipment
- Improved heat sink and charging capabilities
- Higher grade of electric components
- All shipped products are tested
*All item pictures are accurate, if in doubt, do not hesitate and compare our item to your original part.
Why use Mosfet Enhanced technology?
Runs cooler
Runs much cooler than the traditional Shunt voltage regulator rectifier.
Saves gas
Less load on the stator, less work, less fuel is used and you save.
Regulated energy
The power charging your battery is steadier and smooth.
Extended battery life
Extends the battery’s life and cold cranking capacity.
More engine power
Removes stator load resulting in more engine power.
Optimized power
Optimize power delivery by switching the stator coils on or off.