Series Voltage Regulator for Suzuki V-Strom DL 1000 2014-2021 | 32800-31J00 / SH847 aftermarket part replacement
Battery condition is extremely important. No voltage regulator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2021 Suzuki DL 1050 V-Strom
- 2020 Suzuki DL 1050 V-Strom XT
- 2020 Suzuki DL 1050 V-Strom
- 2019 Suzuki DL 1000X V-Strom
- 2019 Suzuki DL 1000 V-Strom
- 2018 Suzuki DL 1000X V-Strom
- 2018 Suzuki DL 1000 V-Strom
- 2017 Suzuki DL 1000 V-Strom
- 2016 Suzuki DL 1000 V-Strom
- 2015 Suzuki DL 1000 V-Strom
- 2014 Suzuki DL 1000 V-Strom
Dimensions:
Width: 119 mm
Length: 100 mm
Height: 38 mm
Fixation holes center to center: 100 mm
Other specifications:
Number of plugs: 2
Number of pins: 5
Minimum Charging Voltage: 14.5 V +/- 0.5 V
Maximum Charging Current: 50 A / 500 W
Open Circuit Voltage: < 15 V
Operation Temperature: -20°C to 85°C
Before installing your new machied billet alluminum SERIES Voltage Regulator Rectifier :
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
SERIES regulators run much cooler than the Shunt and MOSFET voltage regulator rectifier and way much cooler than OEM parts.
This series voltage regulator is an aftermarket replacement to the renowned SH847 voltage regulator .
Power only flows through the electrical components when the battery is charging.
Allows the stator to have lower current flowing when not used, extending its lifetime.
The regulator is easier to mount because it is smaller than the OEM one.
RMSTATOR’s new SERIES voltage regulator brings better reliability and charging system performance. A SERIES regulator is a significant upgrade over typical shunt type voltage regulators.
A shunt regulator controls battery voltage by grounding the stator coils to dissipate current as heat, rather than sending it on to the battery. SERIES regulators control battery voltage by intermittently disconnecting stator coils from the regulator electronics, limiting current flow through the unit and on to the battery completely.
This results in lower regulator and stator temperatures, more accurate voltage regulation, and increased reliability of your charging system components.
INSTALL LIKE A PROWe include the opposite connector (main harness side) as we know these are often melted / corroded / defective. Defective connectors are a major cause for repetitive electrical issues.