Stator for Arctic Cat EXT 580 Pantera 580 Powder Special 500 580 600 ZL 500 580 600 ZR 500 580 600 EFI L/C 1997-2001
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2001 Arctic Cat Pantera 580 EFI L/C
- 2000 Arctic Cat ZR 500 EFI L/C
- 2000 Arctic Cat ZL 580 EFI L/C
- 2000 Arctic Cat ZL 500 EFI L/C
- 2000 Arctic Cat Powder 600 Special EFI L/C
- 2000 Arctic Cat Powder 500 Special EFI L/C
- 2000 Arctic Cat Pantera 580 EFI L/C
- 1999 Arctic Cat ZR 600 EFI L/C
- 1999 Arctic Cat ZR 500 EFI L/C
- 1999 Arctic Cat ZL 600 EFI L/C
- 1999 Arctic Cat ZL 500 EFI L/C
- 1999 Arctic Cat Powder 600 Special LE EFI L/C
- 1999 Arctic Cat Powder 600 Special EFI L/C
- 1999 Arctic Cat Powder 500 Special EFI L/C
- 1999 Arctic Cat Pantera 580 EFI L/C
- 1998 Arctic Cat ZR 600 EFI L/C
- 1998 Arctic Cat Powder 600 Special EFI L/C
- 1998 Arctic Cat EXT 580 EFI L/C
- 1997 Arctic Cat ZR 580 EFI L/C
- 1997 Arctic Cat Powder 580 Special EFI L/C
Interior diameter: 51 mm
Exterior diameter: 114 mm
Thickness: 20 mm
Length of wires stator to connectors: 200 mm
Number of wires: 11
Number of plugs: 4
Number of pins: 11
Wire to wire resistance:
Alternator: Red/Yellow To Red/Yellow = 0.4 ohms +/-20%
Before installing your new stator
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010’’.
Brand new aftermarket stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation.
- Highest grade of lamination materials
- Highest grade of copper winding, resistant to 200 degrees Celsius.
- Connector included
- All products shipped are tested
All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.