Generator Stator for Honda CB500F CB 500 F / CB500X CB 500 X / CBR500R CBR 500 R 2013-2018
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2018 Honda CBR 500 R
- 2018 Honda CB 500 X
- 2018 Honda CB 500 F
- 2017 Honda CBR 500 R
- 2017 Honda CB 500 X
- 2017 Honda CB 500 F
- 2016 Honda CBR 500 R
- 2016 Honda CB 500 X
- 2016 Honda CB 500 F
- 2015 Honda CBR 500 R
- 2015 Honda CB 500 X
- 2015 Honda CB 500 F
- 2014 Honda CBR 500 R
- 2014 Honda CB 500 X
- 2014 Honda CB 500 F
- 2013 Honda CBR 500 R
- 2013 Honda CB 500 X
- 2013 Honda CB 500 F
Interior diameter : 54 mm
Exterior diameter : 125 mm
Thickness : 25 mm
Length of wires stator to grommet : 80 mm
Length of wires grommet to plug : 50 mm
Length of pickup coil's wire to grommet : 35 mm
Other specifications :
Number of wires : 5
Number of plugs : 2
Number of pins : 5
Wire to wire resistance :
Alternator : Yellow to Yellow = 0.4 ohms +-20%
Pickup : Yellow to White = 120 ohms +-20%
Before installing your new stator
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010''.
Brand new aftermarket stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- Highest grade of lamination materials
- Highest grade of copper winding, resistant to 200 degrees Celsius.
- Pick up pulsar coil included
- Connector included
- Rubber grommet included
- All products shipped are tested
Fits Mitsuba charging systems
All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.