High Output Stator for Yamaha YFZ 450 2004-2009 2012-2013
Before buying your piece:
Compare the pictures of our wiring and connector configuration for this part to your original. It will only replace a stator with the exact same configuration.
There was another stator used for some of the same fitments by Polaris.
If your original stator has a large 16-terminal connector that plugs into your CDI box, the stator you need is RM01330.
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
5TG-81410-01-00
5TG-81410-02-00
5TG-81410-03-00
5TG-81410-10-00
Dimensions:
Interior diameter: 30mm
Exterior diameter: 85mm
Thickness: 10mm
Length of wires stator to grommet: 180mm
Length of wires grommet to plug: 700mm
Length of pickup coil's wire to grommet: 90mm
Other specifications:
Number of wires: 4
Number of plugs: 2
Number of pins: 4
Wire to wire resistance:
Alternator: White to Yellow = 0.4ohms +/-20%
Pickup: White to Red = 275ohms =+/-20%
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code then youメre original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010メメ.
Brand new high output stator
- Direct replacement to your original unit
- Pick up pulsar coil included
- Connector included
- Opposite connector included
- Rubber grommet included
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- All products shipped are tested
20% More output over stock, works with all other OEM components.
*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.