Generator Stator for Yamaha Venture 700 / SX Viper 700 / SRX 700 2000-2006
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2006 Yamaha SX Viper 700 Mountain
- 2005 Yamaha SX Viper 700 Mountain
- 2004 Yamaha Venture 700
- 2004 Yamaha SX Viper 700 S
- 2004 Yamaha SX Viper 700 Mountain
- 2004 Yamaha SX Viper 700 ER
- 2003 Yamaha SX Viper 700 Mountain
- 2003 Yamaha SX Viper 700 ER
- 2003 Yamaha SX Viper 700
- 2002 Yamaha SX Viper 700 ER
- 2002 Yamaha SX Viper 700
- 2002 Yamaha SRX 700
- 2001 Yamaha SRX 700
- 2000 Yamaha SRX 700
8DN-81410-00-00
8EK-81410-01-00
8EK-81410-10-00
Interior diameter: 42 mm
Exterior diameter: 104 mm
Thickness: 19 mm
Length of wires stator to grommet: 65 mm
Length of wires grommet to plug: 180 mm
Length of pickup coil's wire to grommet: 80 mm
Other specifications :
Number of wires: 5
Number of plugs: 2
Number of pins: 5
Wire to wire resistance :
Alternator: White Between each White = 0.4 ohms +/-20%
Pickup: Red to Green = 200 ohms +/-20%
Before installing your new stator
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010’’.
Brand new aftermarket stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation.
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Pick up pulsar coil included
- Connector included
- Rubber grommet included
- All products shipped are tested
We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues.
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.