Generator Stator for Kawasaki Ninja 650 | 650 R EN Vulcan | 650 Versys 650 | Z 650 2012-2021 | 21003-0118 21003-0206
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2021 Kawasaki Z 650
- 2021 Kawasaki Vulcan S 650 EN650
- 2021 Kawasaki Versys 650
- 2021 Kawasaki Ninja 650
- 2020 Kawasaki Z 650
- 2020 Kawasaki Vulcan S 650 EN650
- 2020 Kawasaki Versys 650
- 2020 Kawasaki Ninja 650
- 2019 Kawasaki Z 650
- 2019 Kawasaki Vulcan S 650 EN650
- 2019 Kawasaki Versys 650
- 2019 Kawasaki Ninja 650
- 2018 Kawasaki Z 650
- 2018 Kawasaki Vulcan S 650 EN650
- 2018 Kawasaki Versys 650
- 2018 Kawasaki Ninja 650
- 2017 Kawasaki Z 650
- 2017 Kawasaki Vulcan S 650 EN650
- 2017 Kawasaki Versys 650
- 2017 Kawasaki Ninja 650
- 2016 Kawasaki Vulcan S 650 EN650
- 2016 Kawasaki Ninja 650
- 2015 Kawasaki Vulcan S 650 EN650
- 2015 Kawasaki Ninja 650
- 2014 Kawasaki Ninja 650
- 2013 Kawasaki Ninja 650 R
- 2013 Kawasaki Ninja 650
- 2012 Kawasaki Ninja 650 R
21003-0164
21003-0153
21003-0206
Dimensions :
Interior diameter : 42 mm
Exterior diameter : 104 mm
Thickness : 18 mm
Length of wires stator to grommet : 105 mm
Length of wires grommet to plug : 310 mm
Other specifications :
Number of wires : 3
Number of plugs : 1
Number of pins : 3
Wire to wire resistance :
Alternator : Black to Black = 0.5 ohms +-20%
Before installing your new stator
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulatorrectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010''.
Brand new aftermarket stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Connector included
- Rubber grommet included
- All products shipped are tested
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.