Ignition Stator for Kawasaki KLX 250 1994-1996 / KLX 350 1997-2007 | OEM Repl.# 21003-1274 KLX250 KLX350
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2007 Kawasaki KLX 300 R
- 2006 Kawasaki KLX 300 R
- 2005 Kawasaki KLX 300 R
- 2004 Kawasaki KLX 300 R
- 2003 Kawasaki KLX 300 R
- 2002 Kawasaki KLX 300 R
- 2001 Kawasaki KLX 300 R
- 2000 Kawasaki KLX 300 R
- 1999 Kawasaki KLX 300 R
- 1998 Kawasaki KLX 300 R
- 1997 Kawasaki KLX 300 R
- 1996 Kawasaki KLX 250
- 1995 Kawasaki KLX 250
- 1994 Kawasaki KLX 250
Interior diameter : 35 mm
Exterior diameter : 93 mm
Thickness : 18 mm
Length of wires stator to grommet : 130 mm
Length of wires grommet to plug : 700 mm
Length of pickup coil's wire to grommet : 60 mm
Other specifications :
Number of wires : 6
Number of plugs : 2
Number of pins : 6
Wire to wire resistance :
Alternator : Yellow to Yellow = 0.9 ohms +-20%
Source coil : Red to Black = 160 ohms +/-20%
Pickup : Green/White to White = 250 ohms +-20%
Before installing your new stator
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Brand new aftermarket stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- Highest grade of lamination materials
- Highest grade of copper winding, resistant to 200 degrees Celsius.
- Pick up pulsar coil included
- Connector included
- Rubber grommet included
- All products shipped are tested
All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.