Stator for Suzuki RM125 RM250 125 250 1986-1995
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
Interior diameter : 28 mm
Exterior diameter : 58 mm
Thickness : 15 mm
Length of wires stator to grommet : 45 mm
Length of wires grommet to plug : 500 mm
Length of pickup coil's wire to grommet : 60 mm
Other specifications :
Number of wires : 4
Number of plugs: 3
Number of pins : 4
Wire to wire resistance :
Pickup : Green To Blue = 102 ohms +/-20%
Source : Black/Red To Red/White = 168 ohms +/-20%
Before installing your new stator
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible but no less than 0.010’’.
Brand new aftermarket Stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation.
- Highest grade of lamination materials
- Highest grade of copper windings, resistant to 200 degrees Celsius.
- Pick up pulsar coil included
- Rubber grommet included
- Back plate included
- All products shipped are tested
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.