Stator for Honda CBR 1100 XX VF 750 Magna V45 VFR 750 Interceptor VFR 800 Interceptor 1994-2007
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2007 Honda CB 900 F
- 2006 Honda CB 900 F
- 2005 Honda CB 900 F
- 2004 Honda CB 900 F
- 2003 Honda VF 750 Magna V45
- 2003 Honda CB 900 F
- 2002 Honda VF 750 Magna V45
- 2002 Honda CB 900 F
- 2001 Honda VF 750 Magna V45
- 2000 Honda VF 750 Magna V45
- 1999 Honda VFR 800 Interceptor
- 1999 Honda VF 750 Magna V45
- 1998 Honda VFR 800 Interceptor
- 1998 Honda VF 750 Magna V45
- 1998 Honda CBR 1100 XX
- 1997 Honda VFR 750 Interceptor
- 1997 Honda VF 750 Magna V45
- 1997 Honda CBR 1100 XX
- 1996 Honda VFR 750 Interceptor
- 1996 Honda VF 750 Magna V45
- 1995 Honda VFR 750 Interceptor
- 1995 Honda VF 750 Magna V45
- 1994 Honda VFR 750 Interceptor
- 1994 Honda VF 750 Magna V45
Interior diameter : 42 mm
Exterior diameter : 107 mm
Thickness : 24 mm
Other specifications :
Number of wires : 3
Wire to wire resistance :
Alternator : Between each Yellow = 0.9 ohms+/-20%
Alternator : Yellow to Ground =ﾠO.L. ON DISPLAY
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Brand new stator
- You must re-install your original grommet and the new connector (see picture).
- Once your connector and grommet is re-installed, our part becomes a Plug-and-play unit, direct fit, and very easy to install.
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- All product shipped are tested
*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.