Facebook Pixel

Voltage Regulator Rectifier for Honda XR200R XR 200 R 1987-1990 XR600R XR 600 R 1987-1990

$USD 39.00
Availability: Out of stock
SKU
RMS020-103286

Battery condition is extremely important. No voltage regulator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.

31400-MN1-640
31410-KT0-770
31400-MN1-670
31405-MN1-670
31410-KT0-771

Dimensions:
Width: mm
Length: mm
Height: mm
Wires length: mm
Fixation holes center to center: mm

Other specifications:
Number of plugs:
Number of pins:
Number of wires:
Minimum Charging Voltage: 14.5V +- 0.5V
Maximum Charging Current: 50A500W
Open Circuit Voltage: 15V
Operation Temperature: -20? to 85?

Before installing your new voltage regulator rectifier:

  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulatorrectifier.
  • Check and repair any melted wiring.
  • Use hi-temp dielectric grease on all connectors.

Brand new aftermarket Mosfet voltage regulator rectifier

  • Direct replacement to your original unit.
  • Plug-and-play, direct fit, easy installation.
  • No assembly required
  • Higher grade of electric components.
  • Improved heat sink and charging capabilities
  • The quality exceeds the OEM equipment
  • All products shipped are tested

We have even included the opposite connector (main harness side) as we know these are often melted corroded defective and a major cause for repetitive electrical issues.

All item pictures are accurate, if in doubt do not hesitate and compare our item to your original part.

Write Your Own Review
You're reviewing:Voltage Regulator Rectifier for Honda XR200R XR 200 R 1987-1990 XR600R XR 600 R 1987-1990
Your Rating
Customers Also Viewed
Currently there is no product to display.