Kokusan Stator for KTM 125 EXC-F SX / 150 XC / 200 MXC SX XC / 250 EXC-F SXS / 300 EXC-F MXC / 380 EXC (US) 1997-2016

CAD$ 174.00
Availability: In stock

Please note : This stator ONLY fits our listed KTM models with the Kokusan type ignition usually used on North American market bikes. KTM built the same models for Australian and European markets, and many use an SEM type ignition. This stator will NOT work with SEM ignition models.

Please compare the picture of our stator to your original to be sure, if they look the same, you have the Kokusan ignition, and our stator is compatible. The SEM stator that is not compatible looks very different, it uses 3 mounting bolts instead of our 2, and has a plastic shell covering the core, usually with 'SEM Sweden' stamped into the plastic.

Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.


Dimensions :
Interior diameter : 28 mm
Exterior diameter : 58 mm
Thickness : 16 mm
Length of wires stator to terminals : 640 mm

Other specifications :
Number of wires : 4
Number of plugs : 0
Number of pins : 4

Wire to wire resistance :
Alternator : Between each Yellow = 0.4 ohms +/-20%
Source : Red to White = 30 ohms +/-20%

Before installing your new stator

  • Check the AC output of the stator
  • Replace any burned or corroded connectors on stator and regulator/rectifier
  • Check and repair any melted wiring
  • Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".

*Please compare your original stator with our picture before buying, there are 2 possible stators for some KTM models.

Brand new aftermarket stator

  • You must re-install your original connector and grommet (see picture)
  • Once your connector and grommet is re-installed, our part becomes a plug-and-play unit, direct fit, and very easy to install
  • Higher grade of electric components
  • Highest grade of copper winding, resistant to 200 degrees Celsius
  • All products shipped are tested

All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.

Write Your Own Review
You're reviewing:Kokusan Stator for KTM 125 EXC-F SX / 150 XC / 200 MXC SX XC / 250 EXC-F SXS / 300 EXC-F MXC / 380 EXC (US) 1997-2016
Your Rating
Customers Also Viewed
Currently there is no product to display.