Flywheel Rotor for Ski-Doo MX Z / MX ZX / Summit 500 600 700 800 cc 2003-2007

CAD$ 174.00
Availability: In stock

Please note:

  • This flywheel fits the STD models ONLY.

  • The STD and RER / Trail models of the Ski-Doo 500/600/700/800cc do not use the same stator and flywheel.

  • For the RER / Trailmodels, please use flywheel RM11510 or flywheel & puller kit RMS900-103564.

  • You can determine the correct flywheel by measuring the length of the lump (timing trigger ridge) on outside edge of the flywheel.

  • This STD version has a 25 mm / 1" long trigger.

  • The RER / Trail version (RM11510) has a 60 mm / 2.5 " long trigger.

  • All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.


Exterior Diameter: 128 mm
Interior Diameter: 104 mm
Interior Diameter Center Housing: 27 mm
Exterior Diameter Center Housing: 24 mm
Thickness (exterior): 53 mm
Thickness (interior): 38 mm
Long Lump (timing trigger ridge): 25 mm

Before attempting to start your Ski-Doo, adjusting the air gap is necessary. Rotate the flywheel so the raised node is lined up with the pick up/pulsar coil and adjust as close as possible but no less than 0.010’’.

Our flywheel is manufactured to OEM specs and is covered by a warranty that brings you peace of mind.

Features :

  • Heavy duty flywheel rotor with stainless steel capping & high strength epoxy that completely prevents magnet failure.
  • All parts are tested through an extensive quality control process to ensure correct operation.
Write Your Own Review
You're reviewing:Flywheel Rotor for Ski-Doo MX Z / MX ZX / Summit 500 600 700 800 cc 2003-2007
Your Rating
Customers Also Viewed
Currently there is no product to display.