Kit High Performance CDI Box + Voltage Regulator Rectifier for Kawasaki KLF 400 Bayou 1993-1999
CDI Box:
Dimensions:
Height: 25mm
Length: 95mm
Width: 55mm
Other specifications:
Number of plugs: 2
Number of pins: 5
Voltage Regulator Rectifier:
Dimensions :
Width : 80mm
Length : 88mm
Height: 27mm
Fixation holes center to center : 65mm
Wires length: 110mm
Other specifications :
Number of plugs : 1
Number of pins : 6
Minimum Charging Voltage: 14.5V +/- 0.5V
Maximum Charging Current: 25A-35A/300W-500W
Open Circuit Voltage: <15V
Operation Temperature: -20⁰ to 85⁰
IT IS THE REASON FOR CDI FAILURES.
CDI Box
Our CDI may use a different wire color code then your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This CDI is designed as a direct plug-in replacement and should be used as such.
Voltage Regulator Rectifier
Before installing your new voltage regulator rectifier;
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors.
IT IS THE REASON FOR CDI FAILURES.
Kit High Performance CDI Box + Voltage Regulator Rectifier
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- No assembly required
- All shipped products are tested
All item pictures are accurate, if in doubt, do not hesitate and compare our item to your original part.
Brand new high performance CDI Box
- Enhanced timing curve, increased rev limiter (approximately 1000 rpm)
- Higher grade of electronic components
Brand new voltage regulator rectifier
- Higher grade of electric components
- Improved heat sink and charging capabilities