Stator for Ski-Doo Formula 380 500 | MX Z 440 |Skandic 500 | Lynx 6900 | XR 500 | Forest 440 1995-2003 | OEM# 420886605
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2003 Ski-doo Skandic 503 WT Carb F/C
- 2003 Ski-doo Skandic 503 SWT Carb F/C
- 2003 Ski-doo Skandic 500 SWT Carb F/C
- 2003 Lynx 6900 FCE
- 2002 Ski-doo Skandic 503 WT Carb F/C
- 2002 Ski-doo Skandic 503 SWT Carb F/C
- 2002 Ski-doo Skandic 500 WT Carb F/C
- 2002 Ski-doo Skandic 500 SWT Carb L/C
- 2002 Ski-doo Skandic 500 Carb F/C
- 2001 Ski-doo Skandic 503 WT Carb F/C
- 2001 Ski-doo Skandic 503 SWT Carb F/C
- 2001 Ski-doo Skandic 500 WT Carb F/C
- 2001 Ski-doo Skandic 500 SWT Carb L/C
- 2001 Ski-doo Skandic 500 Carb F/C
- 2001 Lynx Enduro 400
- 2001 Lynx 5900 FCE
- 2001 Lynx 5900 FC
- 2000 Ski-doo Skandic 503 WT Carb F/C
- 2000 Ski-doo Skandic 503 SWT Carb F/C
- 2000 Ski-doo MX Z 440 Carb F/C
- 2000 Ski-doo Formula S 380 Carb F/C
- 2000 Lynx XR 500F
- 2000 Lynx Touring 400F
- 2000 Lynx Forest
- 2000 Lynx 6900 FCE
- 1999 Ski-doo Skandic 503 WT Carb F/C
- 1999 Ski-doo Skandic 503 SWT Carb F/C
- 1999 Ski-doo MX Z 440 Carb F/C
- 1999 Ski-doo Formula SL 500 Carb F/C
- 1999 Ski-doo Formula S 380 Carb F/C
- 1999 Lynx XR 500F
- 1999 Lynx XR
- 1999 Lynx Ranger King 500
- 1999 Lynx Light Touring
- 1999 Lynx Forest 440
- 1999 Lynx Forest
- 1999 Lynx 6900 FCE
- 1998 Ski-doo Touring E 380 Carb F/C
- 1998 Ski-doo Touring 440 Carb F/C
- 1998 Ski-doo Skandic 503 WT Carb F/C
- 1998 Ski-doo Skandic 503 SWT Carb F/C
- 1998 Ski-doo Skandic 500 Carb F/C
- 1998 Ski-doo Skandic 380 Carb F/C
- 1998 Ski-doo MX Z 440 Carb F/C
- 1998 Ski-doo Formula SL 500 Carb F/C
- 1998 Ski-doo Formula S 380 Carb F/C
- 1997 Ski-doo Touring E 380 Carb F/C
- 1997 Ski-doo Touring 500 Carb F/C
- 1997 Ski-doo Touring 440 Carb F/C
- 1997 Ski-doo Skandic 503 WT Carb F/C
- 1997 Ski-doo Skandic 503 SWT Carb F/C
- 1997 Ski-doo Skandic 500 WT Carb F/C
- 1997 Ski-doo Skandic 500 Carb F/C
- 1997 Ski-doo Skandic 380 Carb F/C
- 1997 Ski-doo MX Z 440 Carb F/C
- 1997 Ski-doo Formula SL 500 Carb F/C
- 1997 Ski-doo Formula S 380 Carb F/C
- 1996 Ski-doo Touring E 380 Carb F/C
- 1996 Ski-doo Touring 500 Carb F/C
- 1996 Ski-doo Touring 440 Carb F/C
- 1996 Ski-doo Skandic 500 WT Carb F/C
- 1996 Ski-doo Skandic 500 Carb F/C
- 1996 Ski-doo Skandic 380 Carb F/C
- 1996 Ski-doo Formula SL 500 Carb F/C
- 1996 Ski-doo Formula S 380 Carb F/C
- 1995 Ski-doo Touring E 380 Carb F/C
- 1995 Ski-doo Touring 500 Carb F/C
- 1995 Ski-doo Touring 380 Carb F/C
- 1995 Ski-doo Skandic 500 WT Carb F/C
- 1995 Ski-doo Skandic 500 Ski-Hill special Carb F/C
- 1995 Ski-doo Skandic 500 Carb F/C
- 1995 Ski-doo Skandic 380 Carb F/C
- 1995 Ski-doo Formula SL 500 Carb F/C
- 1995 Ski-doo Formula S 380 Carb F/C
Interior diameter : 43 mm
Exterior diameter : 96 mm
Thickness : 28 mm
Length of wires stator to terminals: 170 mm, 235 mm
Other specifications :
Number of wires : 5
Number of plugs : 1
Number of pins : 6
Wire to wire resistance :
Alternator : Yellow to Yellow/Black = 0.4 ohms +/-20%
Source : Green to White = 290 ohms +/-20%
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Brand new aftermarket Stator
- You must re-install your original connector and grommet (see picture).
- Once your connector and grommet is re-installed, our part becomes a plug-and-play unit, direct fit, and very easy to install.
- Higher grade of electric components.
- Highest grade of copper winding, resistant to 200 degrees Celsius.
- Back Plate included
- All products shipped are tested
All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.