High Output Stator 75W for Yamaha YFS 200 Blaster 1988-2006 | OEM Repl.# 3JM-85560-00-00 / 5VM-85560-00-00
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2006 Yamaha YFS 200 Blaster
- 2005 Yamaha YFS 200 Blaster
- 2004 Yamaha YFS 200 Blaster
- 2003 Yamaha YFS 200 Blaster
- 2002 Yamaha YFS 200 Blaster
- 2001 Yamaha YFS 200 Blaster
- 2000 Yamaha YFS 200 Blaster
- 1999 Yamaha YFS 200 Blaster
- 1998 Yamaha YFS 200 Blaster
- 1997 Yamaha YFS 200 Blaster
- 1996 Yamaha YFS 200 Blaster
- 1995 Yamaha YFS 200 Blaster
- 1994 Yamaha YFS 200 Blaster
- 1993 Yamaha YFS 200 Blaster
- 1992 Yamaha YFS 200 Blaster
- 1991 Yamaha YFS 200 Blaster
- 1990 Yamaha YFS 200 Blaster
- 1989 Yamaha YFS 200 Blaster
- 1988 Yamaha YFS 200 Blaster
3JM-85560-00-00
5VM-85560-00-00
5VM-85560-01-00
Interior diameter : 54 mm
Exterior diameter : 120 mm
Thickness : 15 mm
Length of wires stator to grommet : 80 mm
Length of wires grommet to plug : 380 mm
Length of pickup coil's wire to grommet : 100 mm
Other specifications :
Number of wires : 5
Number of plugs : 5
Number of pins : 5
Wire to wire resistance :
Alternator : Yellow/Red to Black = 0.4 ohms +/-20%
Pickup : White/Red to Black = 20 ohms +/-20%
Source : Black/Red to Green/White = 280 ohms +/-20%
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Brand new high output stator 75 watts
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation.
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- 75 watts output so you can run brighter light
- Connector included
- Rubber grommet included
- Adjustable timing plate to advance and retard up to 10 degrees included
- All products shipped are tested
*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.
